Continental Imports
2662 Bracket View The provided mounting brackets & screws, allow mounting the changer to the car body or factory mounting bracket.
View of optical cable ends Using a small flat screwdriver, disassemble the Factory optical connector and remove the two optical cables. The will be one cable with a red end and one with a clear end.
Becker opticle connectors On the provided adapter cable, open the two metal retainer clips by prying them up with a small screw driver or pair of pliers. This will allow the insertion of the optical cable ends.
Connecting the vehicle to your Becker Insert the optical cables from the car into the corresponding connector. Each connector is keyed to accept only one cable. Lock the cable into place by pressing down the metal clip.
Connecting power to the Becker Insert the vehicle's three pin power connector into the adapter.
Plugging in the Becker adapter Complete the wiring by inserting the adapter into the 2662 interface socket.

Back to previous page.
| Becker Sales |

| Blaupunkt Products And Service | Becker Products And Service |

| VDO Instruments | E-mail Us | Home |

1219 S. Main St.
Gainesville, FL 32601 USA
(352) 377-6604
fax (352) 377-2218
Toll Free
(for orders only please)
(877) 407-2950

Bosch Authorized Service Center
Copyright © 2001 by Continental Imports - All Rights Reserved

Site Designed & Created by Scott Brotherton

Technical difficulties should be reported to
contimpo@continentalimports.com
and could save you 2%
on your purchases.