Continental Imports
Blaupunkt

Blaupunkt De-coding Procedure

These units have factory programmed codes


This radios have been programmed to allow the owner to disarm the code locking feature. The procedure for disarming the code is as follows. The example will use the code "2132". This is only an example of the possible codes, and in no way should be considered a "skeleton key" type of code. The animation that illustrates the process may not look like your unit, however the buttons to push and the display readout will be the same (unless noted later in this example).

Blaupunkt Display Animation

Disarming the Code

  1. Turn on the unit. "CodE" will appear in the display.

  2. Touch one of the presets 1 through 4 (the animation shows #1 highlighted in green). The display now shows "0000".

  3. Press preset #1 two times. Each time (the animation shows #1 highlighted in cyan) the button is pushed the display will go to the next higher number. Press preset #2 once (highlighted in cyan). Continue with preset #3, three times, and preset #4, twice. The display will now show "2132".

  4. Press the seek up button (as shown in red). The radio will not activate.

  5. Turn off the unit.

  6. Turn on the unit while holding preset #1 and #4.

  7. CONTINUE to hold #1 and #4 until the display shows "CodE".

  8. Release the buttons and re-enter the code as in steps #1 through #4 above. This will reactive the unit, except that a code will not longer be required after power is lost.


Re-arming the Code

  1. Turn off the unit.

  2. Turn on the unit while holding preset #1 and #4.

  3. CONTINUE to hold #1 and #4 until the display shows "CodE".

  4. Release the buttons and re-enter the code as in steps #1 through #4 in the Disarming instructions. This will reactive the unit, and a code will be needed every time power is lost.

When the Code is armed, "CodE" appears on the display
for one second after the unit is turned on.
Back to previous page.
| Blaupunkt Service | Blaupunkt Products and Service

| E-mail Us | Home |

1219 S. Main St.
Gainesville, FL 32601 USA
(352) 377-6604
fax (352) 377-2218

Bosch Authorized Service Center
Copyright © 2007 by Continental Imports - All Rights Reserved

Site Designed & Created by Scott Brotherton

Technical difficulties should be reported to
contimpo@continentalimports.com
and could save you 2%
on your purchases.