Blaupunkt Coding Procedure

These units are programmed at the factory

Many Blaupunkt radios were equipped with an electronic Anti-Theft system that would render the unit inoperable unless a four digit code was entered. The procedure for entering this code is as follows. The example will use the code "2132". This is only an example of the possible codes, and in no way should be considered a "skeleton key" type of code. The animation that illustrates the process may not look like your unit, however the buttons to push and the display readout will be the same (unless noted later in this example).

Code Animation

Turn on the unit and "CodE" will show in the display.
Press preset #1 two times. Each time (the animation shows #1 highlighted in cyan) the button is pushed the display will go to the next higher number. Press preset #2 once (highlighted in cyan). Continue with preset #3, three times, and preset #4, twice. The display will now show "2132".
To lock in the code and activate the radio, press the seek down button (as shown in red). Your unit will now operate normally until the next time the constant power supply is interrupted.

If you have not entered the correct code, or it was done incorrectly, then the unit will display "----" for 10 seconds. You will then be able to try again but after four attempts the radio will shut down for 20 minutes. Wait for the required time interval (the unit must be left on during this period), and then you can repeat the procedure. You have a total of 16 attempts before the radio shuts down permanently and must be reset at an Authorized Blaupunkt Service Center.

1219 S. Main St.
Gainesville, FL 32601 USA
(352) 377-6604
fax (352) 377-2218

Bosch Authorized Service Center

Copyright © 2007 by Continental Imports - All Rights Reserved

Site Designed & Created by Scott Brotherton

Technical difficulties should be reported to
contimpo@continentalimports.com
and could save you 2%
on your purchases.